Longitudinal strain measurement by 3D modelling from cine CMR: feasibility and comparison to 2D speckle tracking echocardiography

Abstract

<jats:title>Abstract</jats:title> <jats:sec> <jats:title>Background</jats:title> <jats:p>Global longitudinal strain (GLS) has emerged as a sensitive index of left ventricular (LV) systolic function with greater prognostic value than LV ejection fraction (LVEF) in a variety of cardiac disorders. While GLS is routinely derived from 2D speckle tracking echocardiography (STE) and feature tracking in cardiac magnetic resonance (CMR) imaging, calculation of strain via 3D geometric modelling enables analyses of deformation that are independent of 2D image plane constraints.</jats:p> </jats:sec> <jats:sec> <jats:title>Purpose</jats:title> <jats:p>We sought to compare longitudinal strain measurements extracted from geometric 3D analysis of CMR against values obtained from conventional 2D-STE.</jats:p> </jats:sec> <jats:sec> <jats:title>Methods</jats:title> <jats:p>Consecutive 2D-echocardiography (2D-echo) and steady-state free precession multiplanar cine CMR scans were performed in 80 prospectively recruited participants (48 healthy controls with LVEF range 53–74%, 30 patients with non-ischaemic cardiac disease with LVEF range 25–77%, and 2 heart transplant recipients with LVEF 53% and 58%), &amp;lt;1 hour apart. Average endocardial peak GLS from 2D-STE was calculated offline using vendor-independent clinical software from apical triplane (2, 3 and 4-chamber) images for each of the standardised LV walls (anterior, anteroseptal, inferoseptal, inferior, inferolateral, anterolateral). Dynamic 3D geometric models of the LV were reconstructed from 3 long- and 6 short-axis CMR slices over one cardiac cycle. Corresponding longitudinal strain measurements were then evaluated by extracting analogous endocardial arc lengths (apex to base of each LV wall) from the 3D LV model. Finally, an average peak GLS was calculated as the mean of the peak longitudinal strains in each LV wall.</jats:p> </jats:sec> <jats:sec> <jats:title>Results</jats:title> <jats:p>GLS measured by 2D-STE ranged between −6.5% and −27.9% for the study population. A two-way mixed-effects intraclass correlation coefficient (ICC) for absolute agreement of 0.820 (95% CI: [0.720, 0.885]) demonstrated good correlation between average GLS obtained from 2D-STE and CMR. A Bland-Altman analysis revealed a minimal bias (&amp;lt;1%) and 95% limits of agreement (LOA) between −6.3% and 5.5% (Fig. 1), with no apparent proportional bias. Comparatively lower correlation and wider LOA between longitudinal strains from 2D-STE and CMR were observed for each LV wall (Table I).</jats:p> </jats:sec> <jats:sec> <jats:title>Conclusions</jats:title> <jats:p>Fully automated calculation of LV GLS can be obtained from geometric 3D CMR analysis. Average peak GLS from cine CMR exhibits good agreement with 2D-STE, despite showing only moderate agreement at each LV wall. The increased discrepancy in regional longitudinal strain may be attributed to subjective plane positioning in 2D-echo, which can be expected to improve with advances in 3D-STE. The calculation of GLS by 3D geometric modelling may enhance the diagnostic value of routine cine CMR examinations for LV systolic function assessment.</jats:p> </jats:sec> <jats:sec> <jats:title>Funding Acknowledgement</jats:title> <jats:p>Type of funding sources: Public grant(s) – National budget only. Main funding source(s): Health Research Council (HRC) of New Zealand and National Heart Foundation (NHF) of New Zealand Figure 1. Bland-Altman analysisTable I. Regional correlations</jats:p> </jats:sec>